Diagnostic Indicators - Dell PowerEdge FX2 Owner's Manual

Item Indicator, Button, or
Connector
6 Video connector
7 USB connector

Diagnostic indicators

The diagnostic indicators on the system front panel display error status during system startup.
NOTE: No diagnostic indicators are lit when the system is switched off. To start the system, plug it
into a working power source and press the power button.
The following table describes the system conditions and possible corrective actions associated with the
diagnostic indicators.
Table 3. Diagnostic indicators
Health indicator
Condition
If the system is on, and in
good health, the indicator
lights solid blue.
The indicator blinks amber if
the system is on or in
standby, and any error exists
(for example, a failed fan or
hard drive)
Electrical indicator
Condition
The indicator blinks amber if
the system experiences an
electrical error (for example,
voltage out of range, or a
Icon
Corrective Action
None required.
See the CMC Log or system messages for the specific issue.
Corrective Action
See the CMC Chassis Log or system messages for the
specific issue. If it is due to a problem with the power
supply, check the LED on the power supply. Reseat the
power supply by removing and reinstalling it. If the problem
persists, see
Description
• one full-width compute sled and up to
two half-width compute sleds
NOTE: PowerEdge FX2s supports a
combination of compute and storage
sleds. For information on mapping of
storage sleds to compute sleds in
PowerEdge FX2s, see the Dell
PowerEdge FD332 Owner's Manual at
Dell.com/poweredgemanuals.
Enables you to connect a monitor to the
system.
Enables you to connect a keyboard or mouse
to the system.
Getting Help.
11