Logging In To The Cmc - Dell PowerEdge FX2 Owner's Manual

• Connect to one of the compute sleds and boot to the Human Interface Infrastructure (HII)
browser to retrieve the CMC IP address.
10. Connect to the CMC IP address through the Web browser by using the default logon credentials.
NOTE: The default IP address of the CMC is 192.168.0.120. The default user name is root and
password is calvin.
11. Provide each iDRAC with an IP address in the CMC Web interface.
12. Connect to each iDRAC by using a Web browser and type the final configuration of iDRAC.
The default user name is root and password is calvin.
13. Turn on the compute sleds and install the operating system.
Next steps
To see step-by-step instructions for unpacking and installing the enclosure, scan the following Quick
Resource code. For more information about the Quick Resource Locator, see
information by using QRL.
Figure 15. Quick Resource Locator for installing the enclosure

Logging in to the CMC

You can perform the initial network configuration of the chassis management controller (CMC) either
before or after the CMC has an IP address.
You can log in to the CMC as a CMC local user, as a Microsoft Active Directory user, or as an LDAP user.
You can also log in by using the Single Sign-On or Smart Card.
For more information on managing the system and configuring the settings, see the Dell PowerEdge FX2/
FX2s CMC User's Guide at Dell.com/esmmanuals.
24
Accessing system