Fork Disassembly; Front Brake Installation - Honda 2000 XR50R Service Manual

FRONT WHEEL/BRAKE/SUSPENSION/STEERING
FORK
12-12
Install the brake arm by aligning the punch marks
on the arm and brake cam.
Install a new brake arm pinch bolt and nut as
shown and tighten it to the specified torque.
TORQUE: 6 N·m (0.6 kgf.m , 4.3 Ibf·ft)
Apply grease to the anchor pin and brake cam
sliding surfaces. SHOES
Install the brake shoes and spring as shown.
Wipe any excess grease of the brake cam and
anchor pin.
INSTALLATION
Install the front wheel (page 12-8).
DISASSEMBLY
Remove the front wheel (page 12-5),
l oosen the brake cable nut and remove the brake
cable from the fork slider.
Remove the dust seal from the fork outer tube by
sliding it down.
Remove the stopper ring.
Remove the fork t op bolt and washer and pull the
fork slider down to remove the f ork assembly.
•