Service Rules - Honda 2000 XR50R Service Manual

GENERAL INFORMATION
SERVICE RULES
1. Use genuine HONDA or HONDA-recommended parts and lubricants or their equivalents. Parts that don't meet HONDA's
design specifications may causa damage to the motorcycle.
2. Use the special tools designed for this product to avoid damage and incorrect assembly.
3. Use only metric tools when servicing the motorcycle. Metric bolts, nuts and screws are not interchangeable with English
fasteners.
4. Install new gaskets, D-rings, cotter pins. and lock plates when reassembling.
5. When tightening bolts or nuts, begin with the larger diameter or inner bolt first. Then tighten to the specified torque
diagonally in incremental steps unless a parti cular sequence is specified.
6. Clean parts in cleaning solvent upon disassembly. Lubricate any sl iding surfaces before reassembly.
7. After reassembly, check aU parts for proper installation and operation.
8. Aoute all electrical wires as shown on pages 1-14 through '·16, Cable and Harness Routing.
1-2
•
•
•