Chapter 1 - Introduction; New Commands In Firmware Version 8.7.4 - Netopia CLI 874 Cli Reference Manual

Chapter 1
Introduction
This Command Line Interface Commands Reference contains information on the syntax and use of the
Command Line Interface for the Motorola Netopia
the router firmware and troubleshoot problems using the Command Line Interface.
This document is intended for small office, home office, and remote office users, and other networking
professionals who administer networks using Motorola Netopia
Note:
Restrictions among firmware versions are noted in the body of this document. Where no firmware
version is noted, the commands given are supported on all platforms.

New Commands in Firmware Version 8.7.4

Firmware Version 8.7.4 adds new and revised commands for the following:
IP multicast to layer 2 unicast mapping. See
■
Change backup timer from minutes to seconds. See
■
Support for router-generated packets with source address outside of local member range for IPSec force all
■
tunnels. See "Unprotected Services Configuration Commands" on page
Enhanced VLAN Support and configuration changes. See
■
page 2-36.
DHCP Filterset, Option Groups, DHCP Generic Options support. See
■
and Option Filtersets Commands" on page
®
router family. It provides information required to configure
®
routers.
"IGMP Configuration Commands" on page 2-70.
"Backup Configuration Commands" on page
"Virtual LAN (VLAN) configuration commands" on
2-77.
Introduction 1-1
2-68.
"DHCP Gen-Options, Option Groups,
2-115.