Table of Contents
Advertisement
backup failure layer-2 delay 0..65535
no backup failure layer-2 delay
show backup failure layer-2 delay
Note:
Beginning with Firmware Version 8.3.3, these commands are unncessary and consequently no longer
supported.
These commands allow you to specify, disable, or show the layer-2 backup failure delay interval. Note that l2 is
an acceptable synonym for layer-2.
backup recovery rip tx disable [ yes | no ]
no backup recovery rip tx disable
show backup recovery rip tx disable
Note:
These commands are supported beginning with Firmware Version 8.6.1.
These commands allow you to disable, enable, or show the status of RIP services on the primary WAN interface
when the Router is in Backup mode. RIP services ordinarily will continue to run on the primary interface when in
Backup mode, attempting to determine "layer 2" connectivity.
Usually, the no setting is desirable, since it may be required to ping the configured host that determines "layer
2" connectivity. However, RIP running on the recovering primary interface may cause problems specific to your
application. When in Backup mode, RIP routes are still sent and received through the primary interface, even
though that is not the active interface.
Motorola Netopia® Router CLI Commands 2-117
Advertisement
Table of Contents
