Table of Contents
Advertisement
UBR VC: No configuration is needed for UBR VCs.
CBR VC: One parameter is required for CBR VCs, the Peak Cell Rate pcr that applies to the VC. This value
should be between 1 and the line rate. You set this value according to specifications defined by your service
provider.
ISDN WAN Interface configuration commands
interface isdn id line type { switched | leased | idsl-ascend | idsl-cmn }
show interface isdn id line type
show interface isdn id status [ b1 | b2 ]
interface isdn id imux mode { mlppp | dml }
show interface isdn id imux mode
interface isdn id speed { b1 | b2 | 2b | 2b+d }
show interface isdn id speed
interface isdn id switch { auto | ni1 | 5esspttopt | 5essmultipt | dms100 | ts013 | euroisdn |
japanntt | uk-euro }
interface isdn id dn { 1 | 2 } string
no interface isdn id dn { 1 | 2 }
show interface isdn id dn { 1 | 2 }
interface isdn id spid { 1 | 2 } string
no interface isdn id spid { 1 | 2 }
show interface isdn id spid { 1 | 2 }
interface isdn id imux mode { mlppp | dml }
show interface isdn id imux mode
These commands allow you set or show the ISDN interface IMUX bonding mode: Multilink PPP or DML (for
Copper Mountain Networks central office equipment).
Example:
interface isdn 1 imux mode dml
ISDN WAN Interface Configuration Commands
Generic ISDN
Permanent ISDN (IDSL) only
Switched ISDN only
Motorola Netopia® Router CLI Commands 2-45
Advertisement
Table of Contents
