Netopia CLI 874 Cli Reference Manual page 43

This command specifies the IP address of the next server in the boot process, typically a Trivial File Transfer
Protocol (TFTP) server.
show interface ethernet id ip dhcp client status
Note:
This command is supported beginning with firmware version 8.5.
This command allows you to display the status of the ethernet WAN being served via DHCP. It displays:
interface ethernet id address-serve gateway { gw-ip-addr | default { ip-addr/mask-bits |
ip-addr mask } }
show interface ethernet id address-serve gateway
This command allows you to specify the gateway IP address that will be served to clients requesting an address
via an address serving protocol that can serve a gateway address. You may specify a gateway IP address for
each Ethernet subnet for which you have configured an address-serving pool. (See the description of the
interface ethernet id address-serve range command on
If you specify the keyword default, you must also specify an Ethernet subnet; the gateway IP address for the
specified subnet will be reset to its default value. The default gateway IP address for a particular subnet is
either the router's default gateway (if that gateway is on the specified subnet) or the router's address on the
subnet.
interface ethernet id address-serve helper ip-addr
no interface ethernet id address-serve helper [ip-addr]
show interface ethernet id address-serve helper
These commands allow you to configure or display the addresses of up to four remote DHCP servers to which
the router will forward DHCP requests when it is acting as a DHCP relay agent. The interface ethernet id
address-serve helper command adds the specified IP address to the server list. The no interface ethernet id
address-serve helper command removes the specified IP address from the server list; if you omit the IP
address, all configured DHCP server IP addresses are removed.
Examples:
#show interface ethernet 0 address-serve helper
#interface ethernet 0 address-serve helper 10.0.0.1
#interface ethernet 0 address-serve helper 20.0.0.1
#interface ethernet 0 address-serve helper 30.0.0.1
#no interface ethernet 0 address-serve helper 20.0.0.1
#show interface ethernet 0 address-serve helper
interface ethernet 0 address-serve helper 10.0.0.1
IP Address
IP Gateway
DNS server 1
Lease Expiration
Motorola Netopia® Router CLI Commands 2-31
IP Subnet Mask
DHCP server
DNS server 2 (if any)
page 2-32.)