Table of Contents
Advertisement
T1 WAN Interface Configuration Commands (continued)
interface t1 id rfc1973 dlci { 16..991 }
show interface t1 id rfc1973 dlci
interface t1 id rfc1973 lmi { annexa | annexd | ansi | ccitt | lmi | none }
show interface t1 id rfc1973 lmi
no interface t1 id rfc1973 lmi
interface t1 id buildout { auto | 0-0.6 | 7.5 | 15.0 | 22.5 }
show interface t1 id buildout
These commands set or display the line buildout for the specified T1 WAN interface.
interface t1 id channels
count integer
[ start integer ]
[ { alternating | contiguous } ]
[ rate { 56 | 64 | 56k | 64k | Nx56k | Nx64k } ]
show interface t1 id channels
These commands set or display which DS0 channels are utilized on the specified T1 WAN interface, and the
rate of those DS0 channels. The count clause is always required. The start clause is required unless the
count clause specifies 24 channels, in which case if the start clause is not present, the starting channel
number is assumed to be channel 1. If neither the alternating nor the contiguous keyword is specified, the
contiguous keyword is assumed unless the line encoding is AMI and the count clause specifies two or more
channels, in which case the alternating keyword is assumed. The rate clause is always optional. If the rate
clause is not present, the value Nx64k is assumed, unless the line encoding is AMI, the count clause specifies
two or more channels, and the contiguous keyword is specified, in which case the value Nx56k is assumed.
interface t1 id clock source { internal | network }
show interface t1 id clock source
These commands set or display the clock source for the specified T1 WAN interface.
interface t1 id dle { ppp | hdlc | rfc1490 }
show interface t1 id dle
These commands set or display the data link encapsulation (DLE) for the specified T1 WAN interface.
Note:
frame-relay is accepted as a synonym for rfc1490.
interface t1 id ds0-autodetect { yes | no }
show interface t1 id ds0-autodetect
no interface t1 id ds0-autodetect
These commands allow you to set, show, or disable DS0 channel auto-detection on the specified T1 interface.
Motorola Netopia® Router CLI Commands 2-63
Advertisement
Table of Contents
