Netopia CLI 874 Cli Reference Manual page 139

ike phase1 { name | index } authentication shared-secret { ascii | hexadecimal } string
This command sets the specified IKE Phase1 profile's shared secret. For security reasons no show variant of
this command exists.
ike phase1 { name | index } dangling-sas { yes | no }
show ike phase1 { name | index } dangling-sas
no ike phase1 { name | index } dangling-sas
These commands set, display, or disable whether or not Phase 2 SAs may persist after the underlying Phase 1
SAs have expired.
ike phase1 { name | index } encryption { des | 3des }
show ike phase1 { name | index } encryption
These commands set or display the specified IKE Phase1 profile's encryption algorithm.
ike phase1 { name | index } group { 1 | 2 | 5 | dh-768-bits | dh-1024-bits | dh-1536-bits }
show ike phase1 { name | index } group
These commands set or display the specified IKE Phase1 profile's Diffie-Hellman group.
Note:
1 and dh-768-bits, 2 and dh-1024-bits, and 5 and dh-1536-bits, respectively, are synonyms.
ike phase1 { name | index } hash { sha1 | md5 }
show ike phase1 { name | index } hash
These commands set or display the specified IKE Phase1 profile's hash algorithm.
show ike status
Note:
This command is supported beginning with firmware version 8.5.
This command allows you to view an IKE session setup.
show ipsec sessions
Note:
This command is supported beginning with firmware version 8.5.
This command allows you to view an IPsec session setup.
ike phase1 { name | index } independent rekeys { yes | no }
show ike phase1 { name | index } independent rekeys
no ike phase1 { name | index } independent rekeys
These commands set or display the specified IKE Phase1 profile's independent phase 2 re-keys setting.
Motorola Netopia® Router CLI Commands 2-127