What's New In 8.7; Chapter 1 — Introduction - Netopia 3341-ENT Firmware User Manual

Chapter 1
Introduction
This Firmware User Guide covers the advanced features of the Netopia ENT Enterprise-Series Router family.
Your Netopia equipment offers advanced configuration features accessed through the Main Menu of the Telnet
configuration screen. This Firmware User Guide documents the advanced features, including advanced testing,
security, monitoring, and configuration. This Firmware User Guide should be used as a companion to the
Quickstart Guide and the Getting Started Guide. You should read the Quickstart Guide and the Getting Started
Guide before reading this Firmware User Guide.

What's New in 8.7

New in Netopia Firmware Version 8.7 are the following features:
•
DoS Detect option in Stateful Inspection. See
•
Default Stateful Inspection installation list of open ports. See
installation" on page 3-10.
•
Additional Syslog messages. See
•
"Procedure for Default Installation for ICSA firewall certification of Small/Medium Business Category
Module (ADSL Routers)" on page
•
IGMP V3 support. See
•
Wireless Multi-media (WMM) support. See
•
IKE Dead Peer Detection timeout now defaults to 20 seconds. See
page 6-7.
•
Support of VLAN ID 0. See
Corresponding commands have been added to the Command Line Interface (CLI). In addition:
•
New show wireless clients and show wireless statistics commands.
•
Broadcast WAN routes via RIP "Yes/No" is now a configurable option. See rip exclude-wan-routes CLI
option to all WAN interfaces.
•
CLI now supports initiating a telnet session from the command line.
See the Command Line Interface Commands Reference available on the Netopia website.
"Log event dispositions" on page
3-48.
"IGMP (Internet Group Management Protocol)" on page
"Wireless Multimedia (WMM)" on page
"VLAN Configuration" on page
"Stateful Inspection" on page
"Open ports in default Stateful Inspection
3-43.
"Advanced IKE Phase 1 Options" on
3-11.
Introduction 1-1
3-3.
3-39.
3-25.