Netopia CLI 874 Cli Reference Manual page 76

2-64 Command Line Interface Commands Reference
interface t1 id framing { d4 | esf }
show interface t1 id framing
These commands set or display the framing mode for the specified T1 WAN interface.
interface t1 id encoding { ami | b8zs }
show interface t1 id encoding
These commands set or display the line encoding for the specified T1 WAN interface.
Note:
If this command changes the line encoding from b8zs to ami and there are two or more contiguous
Nx64k channels in use, the channel data rate will be changed to Nx56k.
interface t1 id operation line type { normal | copper-mountain }
show interface t1 id operation line type
These commands set or display the operation mode for the specified T1 WAN interface. The keyword
copper-mountain should be specified when connected to a Copper Mountain DSLAM T1 line card; the keyword
normal should be specified in all other situations.
interface t1 id prm-enable { yes | no }
show interface t1 id prm-enable
no interface t1 id prm-enable
These commands set or display whether or not ANSI PRMs are sent on the specified T1 WAN interface.
interface t1 id rfc1973 enable { yes | no }
show interface t1 id rfc1973 enable
no interface t1 id rfc1973 enable
These commands set or display whether or not PPP in Frame Relay (RFC1973) is enabled on the specified T1
WAN interface.
interface t1 id rfc1973 dlci { 16..991 }
show interface t1 id rfc1973 dlci
These commands set or display the DLCI used for PPP in Frame Relay (RFC1973) on the specified T1 WAN
interface.
interface t1 id rfc1973 lmi { annexa | annexd | ansi | ccitt | lmi | none }
show interface t1 id rfc1973 lmi
no interface t1 id rfc1973 lmi
These commands set or display the Local Management Interface (LMI) type for PPP in Frame Relay (RFC1973)
on the specified T1 WAN interface.