Netopia CLI 874 Cli Reference Manual page 81

remote-server unprotected no
service unprotected [ yes | no ]
show service unprotected
no service unprotected
These commands allow you to specify, show, or disable whether or not a service is "unprotected."
unprotected indicates whether traffic will be sent over a force-all IPSec tunnel or not. All services default to
unprotected no, meaning that they will be routed over the IPSec tunnel, unless set to yes.
The no default enhances security since it requires user intervention to prevent the service from being routed
over the IPSec tunnel.
If no is used with the commands, the value goes back to the default 0.0.0.0 and no.
Examples:
■ RADIUS, TACACS+
The remote-server configuration controls the settings for both TACACS+ and RADIUS servers.
remote-server interface 0.0.0.0
remote-server unprotected no
SNMP
■
By default, SNMP services use the primary WAN interface, thus no interface selection is required.
■ syslog
system syslog interface 0.0.0.0
system syslog unprotected no
NTP
■
ip ntp interface 0.0.0.0
ip ntp unprotected no
■ heartbeat
heartbeat uses the primary WAN interface, thus no interface selection is required.
heartbeat unprotected no
If the service fails, a message will be added to the event log. This message has the format;
[service] failed. Could not open socket
Motorola Netopia® Router CLI Commands 2-69