Restricted Wan Interface Configuration Commands - Netopia CLI 874 Cli Reference Manual

2-44 Command Line Interface Commands Reference
show interface intf-type id statistics
show interface intf-type id stats
These commands allow you to display statistics for the specified interface, including receive frames, octets,
and errors, and transmit frames, octets, and errors. For switched ISDN interfaces, the statistics are broken
down by channel.
show interface wan id status
Note:
This command is supported beginning with firmware version 8.5.
This command allows you to view the general status of the WAN. It displays:
■ Interface type
■ MAC address
■ IP Address
Status (Down, Activating, or Connected)
■
interface wan 0 tracking { yes | no }
For D-Series CSU/DSU equipment, this command allows you to track or not track the primary interface speed.
Specifying yes means the primary interface (AUX) speed will be tracked, which is the default. Changing this to
no currently means that we will be running at 1.5 MHz.
Restricted WAN Interface configuration commands
interface { adsl | ethernet | isdn | sdsl } id pppoe enable { yes | no }
no interface { adsl | ethernet | isdn | sdsl } id pppoe enable
show interface { adsl | ethernet | isdn | sdsl } id pppoe enable
These commands allow you enable, disable, or show the PPP over Ethernet behavior of the specified interface.
interface { adsl | sdsl } id pvc { id | tag } { yes | no }
This command allows you to enable or disable a Permanent Virtual Circuit (PVC) on the specified ADSL or SDSL
interface.
interface { adsl | sdsl } id pvc { id | tag } pcr num
show interface { adsl | sdsl } id pvc { id | tag } pcr
These commands allow you to assign or show a Peak Cell Rate value (PCR) on a specified Permanent Virtual
Circuit (PVC) on an ADSL or SDSL interface.
®
Motorola Netopia routers support two ATM classes of service for data connections: Unspecified Bit Rate (UBR)
and Constant Bit Rate (CBR). You can configure these classes of service on a per VC basis. The default ATM
class of service is UBR for data. The ATM class of service is not configurable for voice virtual circuits.