Manual Connect/Disconnect Commands; Backup Configuration Commands; Rip-2 Md5 Configuration Commands - Netopia CLI 874 Cli Reference Manual

Manual connect/disconnect commands

connect cp { name | index }
Invoking this command with a valid, applicable connection profile will cause the router to attempt to make the
appropriate connection, using the profile's settings. A valid, applicable connection profile must be either a
profile that matches the primary WAN interface's data link encapsulation, or a tunnel profile.
If the specified profile is valid in this context, the console remains in a modal state until one of the following
occurs:
■ you type Control-C
■ the connection is established, in which case the word "connect" is displayed
■ the connection fails, in which case the word "down" is displayed, followed by an appropriate error message
disconnect cp { name | index }
This command allows you to disconnect the connection, if any, associated with the specified profile. If no
connection is in place an error message is displayed. This command returns immediately; the connection
disconnect process may still be in progress since it is asynchronous.
Backup configuration commands
cp { name | index } interface-group { primary | backup | auxiliary }
show cp { name | index } interface-group
These commands allow you to set or show the interface group to which the dial backup feature is applied.
Note:
auxiliary is only allowed if the router is an Ethernet-to-Ethernet router that has the dial-in kit installed.
RIP-2 MD5 configuration commands
cp id ip rip auth key id
no cp id ip rip auth key id
show config cp id ip rip auth key
These commands allow you to create, delete, or show the RIP-2 Authentication key(s) on the specified
Connection Profile.
cp id ip rip auth key id start date date
show cp id ip rip auth key id start date
These commands allow you to set or show a start date for the RIP-2 Authentication key(s) on the specified
Connection Profile.
cp id ip rip auth key id start time time
show cp id ip rip auth key id start time
These commands allow you to set or show a start time for the RIP-2 Authentication key(s) on the specified
Connection Profile.
Motorola Netopia® Router Connection Profile Commands 3-19