Ip Nat Passthrough Commands - Netopia CLI 874 Cli Reference Manual

3-20 Command Line Interface Commands Reference
cp id ip rip auth key id end date date
show cp id ip rip auth key id end date
These commands allow you to set or show an end date for the RIP-2 Authentication key(s) on the specified
Connection Profile. The acceptable year range is from 1904 – 2039.
cp id ip rip auth key id end time time
show cp id ip rip auth key id end time
These commands allow you to set or show an end time for the RIP-2 Authentication key(s) on the specified
Connection Profile.
cp id rip auth key id end time mode { infinite | date }
show cp id ip rip auth key id end time mode
These commands allow you to set or show the end time mode for the RIP-2 Authentication key(s) on the
specified Connection Profile. date specifies that an expiration date and time will be used; infinite specifies that
the key will never expire.
cp id rip auth key id key <string>
These commands allow you to assign a RIP-2 Authentication key on the specified Connection Profile. Keys must
be manually entered and must consist of 1 – 16 ASCII characters each.

IP NAT Passthrough Commands

Note:
The commands in this section are supported beginning with Firmware Version 8.2.
cp { name | index } ip nat passthrough enable { yes | no }
no cp { name | index } ip nat passthrough enable
show cp { name | index } ip nat passthrough enable
These commands allow you to enable, disable, or show the NAT passthrough behavior for the specified
Connection Profile. The IP passthrough feature allows for a single LAN PC to have the router's public address
assigned to it, in addition to providing PAT (NAPT) via the same public IP address for all other hosts on the
private LAN subnet.
cp { name | index } ip nat passthrough dhcp enable { yes | no }
no cp { name | index } ip nat passthrough dhcp enable
show cp { name | index } ip nat passthrough dhcp enable
These commands allow you to enable, disable, or show the NAT passthrough DHCP behavior for the specified
Connection Profile. This governs DHCP addressing for the passthrough host.
cp { name | index } ip nat passthrough dhcp mac-address { mac-address }
show cp { name | index } ip nat passthrough dhcp mac-address
These commands allow you to set or show the NAT passthrough DHCP MAC address for the specified
Connection Profile. This specifies the MAC address of the passthrough host.