Table of Contents
Advertisement
Motorola Netopia® Router CLI Commands 2-35
interface ethernet id ip vrrp vrouter id preempt-mode enable [ no | yes | on | off ]
show interface ethernet id ip vrrp vrouter id preempt-mode enable
These commands allow you to enable, disable, or display the status of preempt mode. The default is enabled.
interface ethernet id ip vrrp vrouter id enable [ no | yes | on | off ]
show interface ethernet id ip vrrp vrouter id enable
These commands allow you to enable, disable, or display the status of the Virtual Router.
no interface ethernet id ip vrrp vrouter id
This command allows you to delete a Virtual Router.
show interface ethernet id ip vrrp wan-monitor enable [ { yes | no | on | off } ]
show interface ethernet id ip vrrp wan-monitor enable
These commands allow you to enable, disable, or display the status of the WAN monitor.
interface ethernet id ip vrrp master-dhcp-srv enable [ { yes | no | on | off } ]
show interface ethernet id ip vrrp master-dhcp-srv enable
These commands allow you to enable, disable, or display the status of the DHCP behavior. The Virtual Router
can either serve or relay DHCP only if it is in Master state.
interface ethernet id ip vrrp dhcp-gateway ip-addr
show interface ethernet id ip vrrp dhcp-gateway
These commands allow you to specify or display the Virtual Router DHCP gateway IP address.
Advertisement
Table of Contents
