Arp And Bridge Timeout Settings; Scheduled Connections Configuration Commands - Netopia CLI 874 Cli Reference Manual

2-98 Command Line Interface Commands Reference

ARP and Bridge timeout settings

Note:
These commands are supported beginning with Firmware Version 8.4.2.
ip arp-timeout timeout
system bridge-timeout timeout
ip arp-timeout timeout
This command allows you to set the timeout value for ARP timeout. Default = 600 secs (10 mins); range = 60
secs - 6000 secs (1–100 mins).
system bridge-timeout timeout
This command allows you to set the timeout value for bridging table timeout. Default = 30 secs; range = 30
secs – 6000 secs (1–100 mins).
Scheduled Connections Configuration Commands
Note:
Commands in this section are supported beginning with Firmware Version 8.3.1.
ARP and Bridge Timeout Settings