Primary Shaft And Output Shaft Assembly; Gear Selector Forks And Gear Selector Drum Unit Installation - Husqvarna TE 125 Workshop Manual

PRIMARY SHAFT AND OUTPUT SHAFT ASSEMBLY

GEAR SELECTOR FORKS AND GEAR SELECTOR DRUM UNIT INSTALLATION

ENGINE OVERHAUL
1. Install:
• Safety washer "1"
• Snap ring "2"
(see fig. 119)
• Make sure of installing a snap ring with the sharp side "a" fa-
cing towards the opposite direction of the washer and gear.
• Make sure that the ends of the snap ring "b" correspond to
the grooves of the splined shaft "c".
119
2. Install:
• Sprocket of 2a "1"
• Push the second sprocket inside the primary shaft "2", as
shown in the figure.
120
1. Install:
• Gear selector fork-L "1"
• Gear selector fork-C "2"
• Gear selector fork-R "3"
• Gear selector drum unit "4"
• Springs
• Gearbox fork shaft "5"
(see fig. 121)
• Reference protrusions on the gear selector forks must face
towards the right side of the engine and be in the following
121
sequence: "R", "C", "L".
2. Check:
• Transmission
Irregular movement
• Thoroughly apply engine oil on each gear and bearing.
• Before assembling the crankcase, make sure the transmission
is in neutral and that gears rotate freely.
122
F1.72
• Mounting depth "a"
106.85-107.05 mm (4.207-4.215 in)
Repair.
Part. N. 8000 H4704 (07-2010)