Husqvarna TE 125 Workshop Manual page 129

WatEr PUmP assEmBLy
New =
part to be replaced upon reassembly
a. Push down.
3. Mechanical seal installing tool.
4. Centre duct shaft bearing installing tool.
Part. N. 8000 H4704 (07-2010)
ENGINE COOLING
06
07
1. Install:
• Water pump seal " 1" UBI (inside water pump housing "2")
• Install water pump seal using the suitable tools.
WarNING!
• Never lubricate the water pump seal surface with
oil or grease.
• Install water pump seal using the special tools and set it at
the specified depth, as shown.
(see fig. 06)
(see fig. 07)
a.
0-0.5 mm (0-0.02 in)
2. Lubricate:
• Water pump seal lip.
• recommended lubricant
• Lithium soap-base grease
3. Install:
• Water pump housing seal "
• Water pump housing plate "
• Impeller shaft.
• Impeller shaft retainer "
• Impeller shaft retainer bolt: 10 Nm (1.0 mkg, 7.2
ft-lb) LOCTITE
F3.9
1".
2".
3".
®