Ed. 01-09-2010
ENGINE
ENGINE REASSEMBLY
Crankshaft and output shaft assembly
-
Heat right-hand side crankcase half on an electric hob.
-
Oil the two bearings, and slightly grease oil seal.
-
Install output shaft and crankshaft inside bearings.
Connecting rod shall be positioned almost vertically.
Do not force the two shafts inside bearings using a hammer, as this
could result in bearings and crankshaft damage.
Primary drive assembly
-
Insert key (1) inside output shaft keyway.
-
Install primary drive sprocket with the collar side (2) on output shaft.
-
Install nut lock washer.
Lock washer prong (3) shall engage inside primary drive sprocket
hole.
Screw nut M14x1.25.
F.17