Primary Drive Gear And Balance Shaft Gear Installation - Husqvarna TE 125 Workshop Manual

pRImARy dRIVE GEAR ANd bALANCE sHAft GEARs INstALLAtION
ENGINE OVERHAUL
1. Install:
• Balance shaft driven gear "1"
• Lock washer
• Balance shaft drive gear "2"
• Primary drive gear
• Washer "3"
• Balance shaft driven gear nut
• Primary drive gear nut
• Align the punching "a" of the balance shaft drive gear "1" to
the punching "b" of the balance shaft driven gear "2".
99
• Make sure of installing the washer so that the sharp side "c"
is facing towards the primary drive gear.
2. tighten:
• Balance shaft driven gear nut "1"
• Primary drive gear nut "2"
•
100
50 Nm (5.0 mkg, 36 ft-lb)
•
60 Nm (6.0 mkg, 43 ft-lb)
• Place the aluminium plate "a" between the balance shaft drive
gear "3" and the balance shaft driven gear "4", then tighten
the balance shaft driven gear nut.
• Place the aluminium plate "b" between the balance shaft drive
gear "3" and the balance shaft driven gear "4", then tighten
the primary drive gear nut.
101
3. Bend the lock washer tab on one of the flat sides of the
nut.
102
F1.58
balance shaft driven gear nut
primary drive gear nut
Part. N. 8000 H4704 (07-2010)