Husqvarna TE 125 Workshop Manual page 47

Part. N. 8000 H4704 (07-2010)
ENGINE OVERHAUL
5. Rotate:
• Crankshaft (various revolutions clockwise)
6. Check:
• Reference " I " "a"
• Align the reference " I " on the generator rotor to the stationary
reference "b" on the generator cover.
• Reference " I " "c"
• Align the reference " I " on the camshaft sprocket to the statio-
nary reference "d" on the cylinder head.
• Misalignment
• Make reference to installation operations mentioned above.
7. Tighten:
• Camshaft sprocket bolt
• Camshaft sprocket bolt 30 Nm (3.0 mkg, 22 ft-lb)
16
WARNING!
• Make sure the camshaft sprocket bolt is tighte-
ned to the specified torque to avoid the bolt from
loosening and damaging the engine.
8. Measure:
• Valve clearance
• Not conforming to specifications
F1.11
Correct.
Adjust.