Clutch Installation - Husqvarna TE 125 Workshop Manual

CLUtCH INstALLAtION

Part. N. 8000 H4704 (07-2010)
ENGINE OVERHAUL
1. Install:
• Spring washer "1" (see fig. 82)
• Install the spring washer as shown in the figure.
2. Install:
• Clutch housing
• Thrust washer "1"
82
• Make sure the thrust washer is installed with sharp side "a"
opposite to the clutch hub.
3. Install:
• Clutch hub "1"
• Lock washer "2"
• Clutch hub nut
• Lubricate clutch hub nut threading and lock washer surface
with engine oil.
• Align notch "a" in lock washer with a thread "b" on the clutch
83
hub.
4. tighten:
• Clutch hub nut "1"
•
70 Nm (7.0 mkg, 50 ft-lb)
• Locking the clutch hub "2" with suitable tool "3", tighten the
clutch hub nut.
84
5. bend the lock washer tab on
one of the flat sides of the nut.
6. Lubricate:
• Friction plates
• Clutch plates
(with recommended lubricant)
• Recommended lubricant
• Engine oil
85
F1.47
Clutch hub nut