Husqvarna TE 125 Workshop Manual page 119

Part. N. 8000 H4704 (07-2010)
MAINTENANCE
18
5.
6.
a.
b.
19 c.
d.
7.
8.
9.
10.
11.
F2.11
• Engine oil drain plug " 2";
• O-ring " 3";
• Spring " 4";
• Engine oil filter " 5".
(see fig.18)
Drain:
• Engine oil (fully, from crankcase).
If the oil filter needs replacing, too, proceed as follows.
Remove oil filter element cover "1" and oil filter element "2".
Install a new O-ring "3".
(see fig.19)
Install the new oil filter element and oil filter element cover.
• Oil filter element cover bolt: 10 Nm (1.0 mkg, 7.2
ft-lb)
Check:
• Engine oil filter.
Dirty Clean.
Install:
• Engine oil filter;
• Spring
• O-ring;
New
• Oil drain plug.
• Oil filter element cover bolt: 10 Nm (1.0 mkg, 7.2
ft-lb)
Fill:
• Crankcase (with the recommended quantity of specified engine oil).
Engine oil capacity
• Total quantity:
Without changing oil filter element
• 0.95 L (1.00 US qt) (0.84 Imp.qt)
When changing oil filter element
• 1.00 L (1.06 US qt) (0.88 Imp.qt)
Install:
• Engine oil filler plug
Start engine, warm it up a few minutes, then stop it.
Check:
• Engine (for engine oil leakage).
1.15 L (1.22 US qt) (1.01 Imp.qt)