Unidirectional Starter Removal - Husqvarna TE 125 Workshop Manual

GENERAtOR REmOVAL

UNIdIRECtIONAL stARtER REmOVAL

ENGINE OVERHAUL
1. Remove:
• Generator rotor nut "1" (see fig. 60)
• Washer
• Holding the generator rotor "2" with suitable tool "3", slacken
the generator rotor nut.
• Do not allow the pulley support to touch the protrusion on
the generator rotor.
60
2. Remove:
• Generator rotor "1"
(with flywheel puller "2")
• Woodruff key
WARNING!
•
• Make sure the flywheel puller is centred on the generator
rotor.
61
1. Remove:
• Unidirectional starter bolts "1" (see fig. 62)
• Locking out the generator rotor "2" with suitable tool "3",
remove unidirectional starter bolts.
• Do not allow the pulley support to touch the protrusion on
the generator rotor.
62
F1.32
protect crankshaft end by setting a suitably sized
socket wrench between flywheel puller kit cen-
tring bolt and the crankshaft.
Part. N. 8000 H4704 (07-2010)