VALVE CLEARANCE ADJUSTMENT
MAINTENANCE
•
The following procedure applies to all valves.
•
Valve clearance shall be adjusted with cold engine, at ambient
temperature.
•
When measuring or adjusting valve clearance, the piston
shall be set at Top Dead Centre (TDC) during the compres-
sion stroke.
1.
Remove:
•
Cylinder head cover
•
Cylinder head cover gasket.
Refer to "CYLINDER HEAD".
•
Remove the cylinder head cover by sliding it off the chassis
tubes.
2.
Remove:
•
Timing mark access screw "
•
Crankshaft end access screw "
3.
Measure:
01
•
Valve clearance
Not conforming to specs
a.
Turn crankshaft counter clockwise.
b.
Align TDC reference "
mark "b" onto generator cover. (see fig.02)
02
c.
Ensure camshaft lobes are positioned as shown. (see fig.03)
03
F2.4
1".
2". (see fig.01)
Valve clearance (with cold engine)
•
Intake
.........0.10-0.14 mm (0.0039-0.0055 in)
•
Exhaust
.........0.20-0.24 mm (0.0079-0.0094 in)
Adjust.
a" on generator rotor to fixed reference
Part. N. 8000 H4704 (07-2010)