Clearing Cmos Data; Clearing Password - NEC EXPRESS5800/100 SERIES N8100-1635F User Manual

7-44 Troubleshooting
The following figure illustrates the jumper switch location.

Clearing CMOS Data

1.
Record the current BIOS settings.
2.
See the section "Preparing for Installation and Removal" as described in Chapter 8 of this
guide to prepare.
3.
Move the clip over pins 1 and 2. Then put it back over pins 10 and 12.
Short-circuit pins 10 and 12 to protect the CMOS data.
Short-circuit pins 1 and 2 to clear the CMOS data.
4.
Run BIOS SETUP utility and restore the parameter settings recorded in Step 1.
5.
Save and exit the SETUP utility.

Clearing Password

1.
See the section "Preparing for Installation and Removal" as described in Chapter 8 of this
guide to prepare.
2.
Move the clip over pins 3 and 4.
Short-circuit pins 10 and 12 to protect the password.
Short-circuit pins 3 and 4 to clear the password.
3.
Run BIOS SETUP utility, and power off the server.
4.
Put the clip back over pins 10 and 12.
5.
Run BIOS SETUP utility, and set the password as needed.
6.
Save and exit the SETUP utility.
<CMOS CLR>
Protect
Clear
<PASSWORD>
Protect
Clear