NAMES AND FEATURES OF COMPONENTS
This section describes the names and features of the components in the device.
Front View
1
POWER/SLEEP lamp (green)
The lamp goes on green when the modular server is powered on.
2
POWER/SLEEP switch
The switch is intended to turn on or off the power of the modular server itself.
Pressing the switch for 4 seconds or longer causes the power supply to be turned off forcibly.
3
DISK ACCESS lamp (green)
The lamp indicates access status of hard disk drive.
4
STATUS lamp (green/amber)
The lamp indicates the status of the modular server. See "Lamp Indications" described later
for the indications and meanings of the lamp.
5
DUMP (NMI) switch
Press this switch to run the memory dump. Not used in usual operation.
6
UID (Unit ID) lamp (blue)
The lamp is intended to identify the modular server in the system. The lamp is lit by a switch
or software command.
When the recognize command is received from software, the lamp blinks.
If you press the ID switch, the lamp goes on.
1
3
4
6
10
Sliding tag
General Description 2-3
2
5
7
8
9
N8100-1635F XXXXXXX
N code
Serial number
Pull straight