Table of Contents
Advertisement
4-8 Configuring Your Modular Server
Main
Option
System Time
System Date
Hard Disk Pre-
Delay
SATA Port 0
Processor
Settings
Language
IMPORTANT:
operation if any of the following conditions is applicable.
After carriage of device
After storage of device
After the device is entered into the pause state under the
environmental condition enduring device operation (temperature:
10°C - 40°C, humidity: 20% - 80%)
Check the system clock at the rough rate of once per month. When the
system clock is installed in a system requiring high time precision, it is
recommended to use a time server (NTP server).
If the system clock is remarkably delayed or advanced as the passage of
time in spite of adjustment, contact your service representative for
maintenance.
Parameter
HH:MM:SS
MM/DD/YYYY
Disabled
3 seconds
[6 seconds]
9 seconds
12 seconds
15 seconds
21 seconds
30 seconds
Information
N/A
[English]
Français
Deutsch
Español
Italiano
Check and adjust the system clock before the
Description
Shows the current time.
Shows the current date.
When accessing the SATA hard disk
drive for the first time during POST,
the system waits for the specified time
until the hard disk drive becomes
ready.
Shows the information on the device
connected to each channel, on the
submenu. The settings of some items
may be changed. However, leave the
items as factory-set.
Select which language BIOS SETUP
displays.
Your Setting
[
]: Factory-set
Advertisement
Table of Contents
Troubleshooting
