NEC EXPRESS5800/100 SERIES N8100-1635F User Manual page 18

1-6 Notes on Using Your Modular Server
The modular server can be powered on by pressing the POWER/SLEEP switch or using
the remote power-on feature from the management PC. In either case, you must wait for at
least 5 seconds before performing power-on operation (after the modular server is inserted
into Module Enclosure, or after the power is supplied to the Module Enclosure).
If power-on operation is performed within 5 seconds, you may fail to power on the
modular server. In such a case, make sure that the power is supplied to the modular server,
then press the POWER/SLEEP switch to turn on the power.
Remove a modular server after turning off the power of the modular server.
Do not perform any of the following operation during POST (including similar operations
from external applications).
– Press the POWER/SLEEP switch of the modular server.
– Remove the modular server from the Module Enclosure.
– Disconnect the power cords from EcoPowerGateway and the power unit of the Module
Enclosure.
Optional memory, hard disk drive, and other electronic components
These components are extremely sensitive to static electricity. Make sure to touch the
metal frame of the equipment to discharge static electricity from your body before
handling the components. Do not touch the terminals or parts on the components by a bare
hand and place the components directly on the desk.
Make sure that the options are NEC-specified optional devices for the modular server.
Even if an option can be installed or connected to the modular server, the option may not
operate properly and further the modular server itself may be defected. If such an option
causes the modular server to be defected or damaged, you will be charged for the repair
within the warranty period.
Do not give excess shocks or vibrations to the hard disk drive. Failure to follow it may
cause the hard disk drive to be defected.
The internal option device contains precision component that is easily affected by drastic
temperature change. If the device is used after storage or relocation, make sure that the
device is fully adapted to the operating environment.
Turn off the cellular phone or pager. Radio interference may cause malfunctions of the
modular server.