NEC EXPRESS5800/100 SERIES N8100-1635F User Manual page 104

7-14 Troubleshooting
Other Messages
Messages displayed on upper line
When STATUS lamp is lighting in green:
On-screen
message
Prepare To Boot
When STATUS lamp is off:
On-screen
message
PCI Bus SERR 01
PCI Bus SERR 07
PCI Bus SERR 09
PCI Bus PERR 01
PCI Bus PERR 07
PCI Bus PERR 09
Description
POST completes
normally.
Description
A system error was
detected on chipset.
A system error was
detected on LAN1 device.
A system error was
detected on LAN2 device.
A system error was
detected on chipset.
A system error was
detected on LAN1 device.
A system error was
detected on LAN2 device.
Action
This is not an error.
Action
1. Take one of the following measures to
reboot (reset) the modular server.
* Issue an OS command.
* Press Ctrl + Alt + Del.
* Issue a command from Web browser of
EXPRESSSCOPE Engine or NEC
ESMPRO Manager.
2. Take one of the following measures to power
off the modular server and then on.
* Power off the modular server from OS,
then press the POWER/SLEEP switch to
power on.
* Press the POWER/SLEEP switch to power
off the modular server, then press it again
to power on.
* Issue a command from Web browser of
EXPRESSSCOPE Engine or NEC
ESMPRO Manager.
3. If the same error persists, contact your
service representative.