Table of Contents
Advertisement
2-8 General Description
USING YOUR MODULAR SERVER
This section describes the basic operation of the modular server.
Power-on of Modular Server
Follow steps below to power on the modular server.
1.
Power on the display unit and peripheral devices connected to the modular server.
2.
Press the POWER/SLEEP switch on the front panel of the modular server.
The POWER/SLEEP lamp on the modular server goes on green.
After a while, POST (Power On Self Test) starts.
POWER/SLEEP switch
IMPORTANT:
initial diagnosis is executed for about 5 seconds. In this period, the
POWER/SLEEP switch is disabled. Power on the modular server about
5 seconds immediately after you installed the modular server in the
Module Enclosure (1way) or power is supplied to the modular server.
While the POST progress screen appears, the modular server runs the self-diagnosis program
(POST) to diagnose the modular server itself. See "POST" described later for details. At the
completion of POST, OS is booted.
NOTE:
message notifying the fault appears. See Chapter 7.
When the power is supplied to the modular server, the
If a fault is found during POST, it is interrupted and the error
POWER/SLEEP switch
Advertisement
Table of Contents
Troubleshooting
