Table of Contents
Advertisement
7-4 Troubleshooting
ERROR MESSAGES
If an error occurs in the modular server, an error message appears.
POST Error Messages
Powering on the modular server automatically starts the self-diagnostic program, POST (Power On
Self-Test). When the POST detects any error, it displays an error message and its measure on the
display unit.
Follow the table below to troubleshoot such errors.
IMPORTANT:
displayed before consulting with your service representative. Alarm
messages are useful information for maintenance.
NOTES:
The POST error messages listed below are for modular server itself.
The POST error message contains POST error code. For example,
"8100" represents the error code in the message [8100: Memory
Error detected in DIMM #1].
On-screen error message
0200
Failure Fixed Disk
0230
System RAM Failed
0231
Shadow RAM Failed
0232
Extend RAM Failed
Take a note on the messages and beep patterns
Recommended action
Contact your service representative.
1. Take one of the following measures to reboot (reset) the
modular server.
* Issue an OS command.
* Press Ctrl + Alt + Del.
* Issue a command from Web browser of EXPRESSSCOPE
Engine or NEC ESMPRO Manager.
2. Take one of the following measures to power off the modular
server and then on.
* Power off the modular server from OS, then press the
POWER/SLEEP switch to power on.
* Press the POWER/SLEEP switch to power off the modular
server, then press it again to power on.
* Issue a command from Web browser of EXPRESSSCOPE
Engine or NEC ESMPRO Manager.
3. Check installation status of DIMMs.
4. Replace the DIMM.
5. If the same error persists, contact your service representative.
Advertisement
Table of Contents
Troubleshooting
