Rackmount Installation; Configuration - Allied Telesis AT-FS716 Installation Manual

Rackmount Installation

Rackmount installation applies to the AT-FS716 and AT-FS724 only. You will
need a Phillips screwdriver for this installation.
Do not use power tools to perform this installation.
1. If previously attached, remove the rubber feet and all cables and power
cord from the switch.
2. Attach the rackmounting brackets to each side of the switch, using the
screws provided.
3. Attach the power cord to the back of the switch.
4. Position the switch in a standard 19-inch rack and secure the switch's
brackets to the rack using the 4 large screws provided.
5. Plug the power cord into the power receptacle. Make sure the
on the front panel lights green.
6. Attach the data cables and observe normal operation as indicated by the
port LEDs. For Port 16/24, set the MDI/MDI-X switch as required. For
typical configuration information, refer to "Configuration" on page 9.
You are finished with rackmount installation.

Configuration

Auto-negotiation for transmission mode supports full-duplex only if the
connected device also negotiates for full-duplex transmission mode.
The following sections discuss standalone, cascade and uplink configurations.
AT-FS716, AT-FS716E, and AT-724I Switches Installation Guide
Caution
Note
3RZHU
LED
9