Cabling Specifications; Electrical Specifications; Utp (Rj45) Connector - Allied Telesis AT-FS716 Installation Manual

Switch Specifications
Safety:
Immunity:

Cabling Specifications

10Base-T:
100Base-TX:
100 m (328 ft) is the maximum distance between switch and network node
connections.

Electrical Specifications

AT-FS716 or AT-FS724I Internal Power:
AT-FS716E External Power: External power adaper provides 13-19 UDC,

UTP (RJ45) Connector

Figure 5 shows an RJ45 connector. For a 100Base-TX link between two switches,
—any two Medium Attachment Units (MAUs)—you typically need a crossover
cable. For a connection to a Network Interface Controller (NIC), the cable is wired
straight-through in accordance with applicable standards.
18
Conforms to all standards normally supported
by Allied Telesyn products, including safety
standards UL 1950, CSA/NRTL (C22.2 950, UL
1950),TUV/GS (EN60950)
IEC 1000-4-2/3/4/6
STP/UTP Category 3,4,5 100 ohm impedance
STP/UTP Category 5 wiring, 100 ohm
impedance
Internal universal power supply with 100 to 240
VAC, 50/60 Hz, 0.3 A input.
800 mA maximum.
Pin 1
Figure 5 RJ45 Connector
Pin 8