B1220, B1620, B1820, WSM
(3) Separating Rear Axle Case
Draining Transmission Fluid
1. Place an oil pan underneath the transmission case, and remove
the drain plugs (1).
2. Drain the transmission fluid.
3. Reinstall the drain plug.
(When refilling)
• Fill new oil from filling port after removing the filling plug (2) up
to the upper notch on the dipstick (3).
• After running the engine for few minutes, stop it and check the
oil level again, if low, add oil prescribed level.
IMPORTANT
• Use only multi-grade transmission oil. Use of other oils
may damage the transmission or hydraulic system. Refer
to "LUBRICANTS, FUEL AND COOLANT" (See page G-9).
• Never work the tractor immediately after changing the
transmission oil. Keep the engine at medium speed for a
few minutes to prevent damage to the transmission.
• Do not mix different brands oil together.
Transmission fluid
Capacity
(1) Drain Plug
(2) Filling Plug
(3) Dipstick
Battery Negative Cable
1. Open the bonnet (1) and remove the front grille (3).
2. Disconnect the battery negative cable (2).
NOTE
• When disconnecting the battery cables, disconnect the
grounding cable first. When connecting, the positive cable
first.
(1) Bonnet
(2) Battery Negative Cable
5-S7
BRAKES
10.5 L
2.77 U.S.gals
2.31 Imp.gals
[A] With Mid-PTO Model
[B] Without Mid-PTO Model
(A) Proper Oil Level
9Y1210272ENS0004US0
(3) Front Grille
9Y1210272TRS0006US0
KiSC issued 07, 2011 A
(EU)