Kubota B1220 Workshop Manual page 138

B1220, B1620, B1820, WSM
Hydraulic Pipes
1. Disconnect the accelerator rod (4) and engine stop rod (3).
2. Remove the power steering delivery pipe (1). [Power steering
model]
3. Disconnect the pipe clamp and the disconnect the 3 point hitch
delivery pipe (5).
4. Disconnect the suction hose (2).
5. Disconnect the glow plug lead wire, thermo sensor lead wire, oil
pressure switch lead wire (6) and starter motor lead wire.
6. Disconnect the stop solenoid connector, alternator connector
and lead wire. [Except B1220]
7. Disconnect the dynamo connector. [Only B1220].
(When reassembling)
Power steering delivery
Tightening torque
pipe nut
(1) Power Steering Delivery Pipe
[Only Power Steering Model]
(2) Suction Hose
(3) Engine Stop Rod
(4) Accelerator Rod
Universal Joint
1. Loosen the clamp (2) and slide the universal joint cover (1) to
the rear.
2. Tap out the spring pin (4).
3. Slide the universal joint (3) to the rear.
(When reassembling)
• Apply grease to the splines of the propeller shaft and universal
joint.
• When inserting the spring pin (4), face the split in the direction
parallel to the universal joint cover (1) so that the water drain
hole may become downward.
• Replace the spring pin (4) with new one.
(1) Universal Joint Cover
(2) Clamp
2-S9
CLUTCH
35 to 45 N·m
3.6 to 4.5 kgf·m
26 to 33 lbf·ft
(5) 3 point Hitch Delivery Pipe
(6) Oil Pressure Switch Lead Wire
[A] Power Steering Model
[B] Manual Steering Model
9Y1210272ENS0008US0
(3) Universal Joint
(4) Spring Pin
9Y1210272ENS0009US0
KiSC issued 07, 2011 A
(EU)