Kubota B1220 Workshop Manual page 315

B1220, B1620, B1820, WSM
Rear PTO Switch Check
1. Disconnect the 2P connector from the rear PTO switch (2).
2. Connect the circuit tester leads to the rear PTO switch 2P
connector.
(When the PTO gear shift lever is in "NEUTRAL" position)
1. Measure the resistance between terminals.
2. If the continuity is not 0 Ω, the switch is faulty, replace it.
(When the PTO gear shift lever is in "540 rpm rear PTO speed
and 2500 rpm mid PTO Speed (If equipped the mid PTO)"
position)
1. Measure the resistance between terminals.
2. If the continuity is not infinity, the switch is faulty, replace it.
(When the PTO gear shift lever is in "540 rpm PTO speed"
position)
1. Measure the resistance between terminals.
2. If the continuity is not infinity, the switch is faulty, replace it.
When the PTO gear shift
lever is in "NEUTRAL"
position
When the PTO gear shift
lever is in "rpm rear PTO
Resistance speed and 2500 rpm mid
PTO Speed (If equipped
the mid PTO)" position
When the PTO gear shift
lever is in "540 rpm PTO
speed" position
(1) PTO Gear Shift Lever
(2) PTO Switch Connector
9-S18
ELECTRICAL SYSTEM
0 Ω
Infinity
[A] PTO Gear Shift Lever "NEUTRAL"
position
[B] PTO Gear Shift Lever "rpm rear
PTO speed and 2500 rpm mid
PTO Speed (If equipped the mid
PTO)" position
[C] PTO Gear Shift Lever "540 rpm
PTO Speed" position
9Y1210272ELS0020US0
KiSC issued 07, 2011 A
(EU)