Kubota B1220 Workshop Manual page 199

B1220, B1620, B1820, WSM
Rear Wheels
1. Place a jack under the transmission case.
2. Loosen the rear wheel cotter setting bolt and nut (1).
3. Take out the wheel hub pin (2).
4. Take out the rear wheel (1).
IMPORTANT
• When re-fitting or adjusting a wheel, tighten the bolts to the
following torques and then recheck them after driving the
tractor approx. 200 m (200 yards).
(When reassembling)
Rear wheel cotter setting
bolt and nut
Tightening torque
Rear wheel hub mounting
nut
(1) Rear Wheel
(2) Wheel Hub Pin
Rear Axle Case (Left Hand Side)
1. Remove the brake rod, L.H. (1) with spring (2).
2. Remove the parking brake rod, L.H. (3). [Except B1220]
3. Remove the pin (5) and parking brake arm (6). [Except B1220]
4. Remove the rear axle case, L.H. (4).
(When reassembling)
• Apply liquid gasket (Three Bond 1206D or equivalent) to joint
face of the rear axle case and differential gear case after
eliminating the water and oil.
Rear axle case mounting
Tightening torque
screw
(1) Brake Rod, L.H.
(2) Spring
(3) Parking Brake Rod, L.H.
[Except B1220]
5-S8
BRAKES
123 to 147 N·m
12.6 to 15.0 kgf·m
91 to 108 lbf·ft
108 to 125 N·m
11.0 to 12.8 kgf·m
80 to 93 lbf·ft
(3) Cotter Setting Bolt
9Y1210272RAS0004US0
40 to 45 N·m
4.0 to 4.6 kgf·m
29 to 33 lbf·ft
(4) Rear Axle Case, L.H.
(5) Pin [Except B1220]
(6) Parking Brake Arm [Except B1220]
9Y1210272RAS0005US0
KiSC issued 07, 2011 A
(EU)