Kubota B1220 Workshop Manual page 161

B1220, B1620, B1820, WSM
Separating the Engine from the Clutch Housing
1. Place the disassembling jack under the center frame.
2. Hoist the engine by the chain at the engine hook.
3. Remove the engine mounting screws, then separate the engine
from the clutch housing with starter motor.
(When reassembling)
• Apply liquid gasket (Three Bond 1206D or equivalent) to join
face of the engine and clutch housing.
Clutch housing and engine
Tightening torque
mounting screw
[A] Power Steering Model
Separating Clutch Housing from Center Frame
1. Place the disassembling stand under the clutch housing (1).
(When reassembling)
Clutch housing mounting
Tightening torque
screw and nut
(1) Clutch Housing
3-S10
TRANSMISSION
18 to 20 N·m
1.8 to 2.1 kgf·m
13 to 15 lbf·ft
[B] Manual Steering Model
9Y1210272ENS0010US0
63 to 72 N·m
6.4 to 7.4 kgf·m
47 to 53 lbf·ft
9Y1210272TRS0038US0
KiSC issued 07, 2011 A
(EU)