B1710 · B2110 · B2410 · B2710, WSM
3. DISASSEMBLING AND ASSEMBLING
[1] SEPARATING REAR AXLE CASE
(1) B1710, B2110, B2410
Draining Transmission Fluid
CAUTION
• Be sure to stop the engine before checking and changing
the transmission fluid.
1. Place oil pan under the tractor.
2. Remove the drain plugs (1) at the bottom of the rear axle case
and oil tank.
3. Drain the transmission fluid and reinstall the drain plugs.
(When refilling)
• Fill new oil from filling port after removing the filling plugs (2) up
to the upper notch on the dipstick (3).
• After running the engine for few minutes, stop it and check the oil
level again, if low, add oil prescribed level.
IMPORTANT
• Use only multi-grade transmission oil. Use of other oils may
damage the transmission or hydraulic system.
Refer to "LUBRICANTS, FUEL AND COOLANT" (See page
G-8).
• Never work the tractor immediately after changing the
transmission oil. Keeping the engine at medium speed for a
few minutes to prevents damage to the transmission.
• Do not mix different blands oil together.
B1710D
B2110D
B2110DB
B2410D
Transmission fluid
B2410DB
capacity
B2110HDB
B2410HDB
(1) Drain Plug
(2) Filling Plug
(3) Dipstick
4-S3
REAR AXLE
11.5 L
3.04 U.S.gals.
2.53 Imp.gals.
12.5 L
3.30 U.S.gals.
2.75 Imp.gals.
A : Oil level is acceptable within this
range
W10108570
KiSC issued 11, 2006 A