Kubota B1220 Workshop Manual page 214

B1220, B1620, B1820, WSM
Bevel Gear Case Gears
1. Remove the internal snap ring (1).
2. Take out the bevel gears (4), (5) with ball bearings (3), (6) and
shims (2).
(When reassembling)
• Install the shims (2) to their original position.
(Reference)
• Thickness of adjusting shims :
0.8 mm (0.031 in.)
1.0 mm (0.039 in.)
1.2 mm (0.47 in.)
1.4 mm (0.055 in.)
(1) Internal Snap Ring
(2) Shim
(3) Ball Bearing
(4) Bevel Gear
Axle
1. Remove the bearing (1).
2. Take out the bevel gear (2).
3. Take out the collar (3).
4. Tap out the axle (4).
(When reassembling)
• Install the oil seal (7) of axle flange (6), noting its direction as
shown in the figure.
• Install the shims (8), (9) to their original position.
(Reference)
• Thickness of adjusting shim (8) :
0.8 mm (0.031 in.)
1.0 mm (0.039 in.)
1.2 mm (0.47 in.)
1.4 mm (0.055 in.)
• Thickness of adjusting shim (9) :
0.8 mm (0.031 in.)
1.0 mm (0.039 in.)
1.2 mm (0.47 in.)
(1) Ball Bearing
(2) Bevel Gear
(3) Collar
(4) Axle
(5) Ball Bearing
6-S8
FRONT AXLE
(5) Bevel Gear
(6) Ball Bearing
(7) Bevel Gear Case
9Y1210272FAS0012US0
(6) Axle Flange
(7) Oil Seal
(8) Shim
(9) Shim
9Y1210272FAS0013US0
KiSC issued 07, 2011 A
(EU)