B1220, B1620, B1820, WSM
Replacing Hydraulic Oil Filter Cartridge
CAUTION
• Be sure to stop the engine before changing the oil filters.
1. Drain the transmission fluid.
2. Remove the hydraulic oil filter cartridge (1) by using a filter
wrench.
3. Apply a slight coat of oil onto the cartridge gasket.
4. To install the new cartridge, screw it in by hand. Over tightening
may cause deformation of rubber gasket.
5. After the new cartridge has been replaced, the transmission
fluid level will normally decrease slightly. Make sure that the
transmission fluid does not leak through the seal. Check the
fluid level.
IMPORTANT
• To prevent serious damage to the hydraulic system. Use
only a KUBOTA genuine filter or its equivalents.
(1) Hydraulic Oil Filter
Checking Clutch Pedal Free Travel
1. Stop the engine and remove the key.
2. Slightly depress the clutch pedal and measure free travel at top
of pedal stroke.
3. If adjustment is needed, loosen the lock nut and turn the
turnbuckle to adjust the rod length within in acceptable limits.
4. Retighten the lock nut.
Clutch pedal free travel "L" on top of
clutch pedal
(1) Clutch Pedal
(2) Lock Nut
G-19
GENERAL
9Y1210272GEG0008US0
15 to 25 mm
0.59 to 0.98 in.
(3) Turnbuckle
9Y1210272GEG0009US0
KiSC issued 07, 2011 A
(EU)