Kubota B1220 Workshop Manual page 135

B1220, B1620, B1820, WSM
Draining Transmission Fluid
1. Place an oil pan underneath the transmission case, and remove
the drain plugs (1).
2. Drain the transmission fluid.
3. Reinstall the drain plug.
(When refilling)
• Fill new oil from filling port after removing the filling plug (2) up
to the upper notch on the dipstick (3).
• After running the engine for few minutes, stop it and check the
oil level again, if low, add oil prescribed level.
IMPORTANT
• Use only multi-grade transmission oil. Use of other oils
may damage the transmission or hydraulic system. Refer
to "LUBRICANTS, FUEL AND COOLANT" (See page G-9).
• Never work the tractor immediately after changing the
transmission oil. Keep the engine at medium speed for a
few minutes to prevent damage to the transmission.
• Do not mix different brands oil together.
Transmission fluid Capacity
(1) Drain Plug
(2) Filling Plug
(3) Dipstick
Steering Wheel
1. Remove the steering wheel cap.
2. Remove the steering wheel mounting nut and remove the
steering wheel (1) with a steering wheel puller (2).
(When reassembling)
Steering wheel mounting
Tightening torque
nut
(1) Steering Wheel
2-S6
CLUTCH
10.5 L
2.77 U.S.gals
2.31 Imp.gals
[A] With Mid-PTO Model
[B] Without Mid-PTO Model
(A) Proper Oil Level
9Y1210272ENS0004US0
30 to 49 N·m
3.0 to 5.0 kgf·m
22 to 36 lbf·ft
(2) Steering Wheel Puller
9Y1210272ENS0005US0
KiSC issued 07, 2011 A
(EU)