Kubota B1220 Workshop Manual page 159

B1220, B1620, B1820, WSM
Fuel Tank
1. Disconnect the fuel hose (4) from the fuel filter, then drain fuel
completely.
2. Disconnect the overflow hoses (1) and pull out the hour meter
cable (7).
3. Disconnect the fuel hose (2) at the feed pump side.
4. Remove the fuel filter assembly. (3).
5. Disconnect the combination light lead wires (5). [Except B1220]
6. Disconnect the key stop timer connector (15), flusher unit
connector (17), starter relay connector (11) and lead wires (16).
[Except B1220]
7. Disconnect the key stop timer connector (15), starter relay
connector (10), regulator connector (18) and lead wires (16).
[Only B1220]
8. Remove the tank frame stay 1 (6) and the tank frame stay 2
(12).
9. Disconnect the fuse box (8) from the fuel tank (14).
10. Remove the fuel tank (14) with tank frame (13).
11. Disconnect the drag link (9).
(When reassembling)
IMPORTANT
• Do not loosen the slotted nut (10) to align the hole.
• Install the cotter pins as shown in the figure.
Tightening torque Slotted nut
(1) Overflow Hose
(2) Fuel Hose
(3) Fuel Filter Assembly
(4) Fuel Hose
(5) Combination Light Lead Wire
[Except B1220]
(6) Tank Frame Stay 1
(7) Hour Meter Cable
(8) Fuse Box
(9) Drag Link
(10) Slotted Nut
(11) Starter Relay Connector
3-S8
TRANSMISSION
18 to 35 N·m
1.9 to 3.5 kgf·m
14 to 25 lbf·ft
(12) Tank Frame Stay 2
(13) Tank Frame
(14) Fuel Tank
(15) Key Stop Timer Connector
(16) Lead Wire
(17) Flusher Unit Connector
[Except B1220]
(18) Regulator [Only B1220]
[A] B1620 and B1820
[B] B1220
9Y1210272ENS0007US0
KiSC issued 07, 2011 A
(EU)