Figure 4 Auto Configuration Option Settings - Yealink W52P Configuration Manual

Dect
Hide thumbs Also See for W52P:
Table of Contents

Advertisement

Device Profile
model using the settings from section
do not exist.
The Standard Options and Advanced Options should already be configured as specified in
section
5.2.2 Configure BroadWorks Device
match the settings in section
The following subsections identify the required settings specific to Device Management.
5.2.2.2.1.1
Configure Auto Configuration Options
If Device Management has been enabled previously for the device profile type(s), proceed
to the next section.
Device Configuration is enabled differently depending on the deployed BroadWorks
release.
For BroadWorks Release 18.0 and later, configure as described in the following table.
Parameter
Device Configuration Options
The following screen capture shows Device Management enablement for BroadWorks
Release 18.0 and later.
For BroadWorks releases prior to Release 18.0, configure as described in the following
table. Note that these settings serve only to enable Device Management and are
otherwise not meaningful in this context.
Parameter
Auto Configuration Type
CPE System File Name
Device File Format
The following screen capture shows Device Management enablement for BroadWorks
release prior to Release 18.0.

Figure 4 Auto Configuration Option Settings

BROADSOFT PARTNER CONFIGURATION GUIDE – YEALINK W52P IP DECT PHONE
©
2013 YEALINK
Configure BroadWorks Device Profile or add the device profile type for each
5.2.2 Configure BroadWorks Device Profile
5.2.2 Configure BroadWorks Device
Value
Device Management
Value
2 Config File
not_used
not_used
Profile. If there are differences, update to
Profile.
Description
Use BroadWorks Device
Management.
Description/Notes
This setting activates the Device
Management configuration items. The 2
Config File button has no relevance to
Device Management, but only activates
the setting field.
This field is not used by Device
Management and should be set to
"not_used".
This field is not used by Device
Management and should be set to
"not_used".
if they
20-BD5392-00
PAGE 26 OF 54

Advertisement

Table of Contents
loading

Table of Contents