Yealink W52P Configuration Manual page 43

network.qos.rtptos =
#Configure the SIP QOS. It ranges from 0 to 63, the default value is
26.
#Require reboot;
network.qos.signaltos =
#Configure the 802.1x mode; 0-Disabled (default), 1-Enabled (EAP-MD5);
#Require reboot;
network.802_1x.mode =
#Configure the username and password for 802.1x authentication.
#Require reboot;
network.802_1x.identity =
network.802_1x.md5_password =
#Enable or disable the VPN feature; 0-Disabled (default), 1-Enabled;
#Require reboot;
network.vpn_enable =
#Enable or disable the LLDP feature; 0-Disabled, 1-Enabled (default);
#Require reboot;
network.lldp.enable =
#Configure the interval (in seconds) the phone broadcasts the LLDP
request. It ranges from 1 to 3600, the default value is 60.
#Require reboot;
network.lldp.packet_interval =
#######################################################################
##
#######################################################################
#Configure the syslog mode; 1-Local, 2-Server;
#Require reboot;
syslog.mode =
#Configure the IP address of the syslog server;
#Require reboot;
syslog.server =
#Configure the syslog level. It ranges from 0 to 6, the default value
is 3.
#Require reboot;
syslog.log_level =
#######################################################################
##
#######################################################################
#Enable or disable the Plug and Play feature; 0-Disabled, 1-
Enabled(default);
auto_provision.pnp_enable =
#Enable or disable the phone to check new configuration when powered
on; 0-Disabled, 1-Enabled (default);
auto_provision.mode =
#Enable or disable the phone to check the new configuration repeatedly;
0-Disabled (default), 1-Enabled;
auto_provision.repeat.enable =
#Configure the interval (in minutes) the phone repeatedly checks the
new configuration. The default is 1440.
auto_provision.repeat.minutes =
BROADSOFT PARTNER CONFIGURATION GUIDE – YEALINK W52P IP DECT PHONE
©
2013 YEALINK
Syslog Server
Auto Provisioning
##
##
20-BD5392-00
PAGE 43 OF 54