Russell Hobbs RHNPC401 Owner's Manual page 9

short bursts. This Pressure Regulator Valve has been factory cali-
brated to release steam from your Pressure Cooker when it reaches
its factory determined maximum pressure capacity (15 psi).
Remove the Pressure Regulator Valve and rinse under lukewarm
water for easy cleaning.(See Important Safety Information section
of this manual for removal instructions.) If this Valve is worn it MUST
be replaced.
CAUTION: Never disassemble Pressure Regulator Valve or clean the
Steam Vent Tube when Pressure Cooker is in use.
PRESSURE INDICATOR SAFETY VALVE
WITH PRESSURE LIFT PIN
This visual safety device indicates if the Pre s s u re Cooke r
Pan is under pre s s u re or if all pre s s u re has been re l e a s e d
f rom the inside of the Pa n . When the Pre s s u re Lift Pin is in
the UP position, you will know the Pre s s u re Cooker Pan is
p re s s u ri z e d . In this position you will not be able to re m ove the
P re s s u re Cooker Lid. It also acts a Pre s s u re Relief Va l ve ,e x h a u s t i n g
excess pre s s u re . The Pre s s u re Lift Pin Gasket should fit snugly aro u n d
the Pin.
If the Pressure Lift Pin is clogged or unclean,it may not function
properly. If the Pressure Lift Pin does not drop when expected,
gently slide the Lid Lock Button towards you to see if the Pressure
Lift Pin drops. If it still does not drop, wait until all steam has been
released.
If this Valve becomes clogged it can easily be cleaned by gently
removing excess food particles from the Valve located on the
underside of the Pressure Cooker Lid.(See Important Safety
Information section of this manual.)
PRESSURE REGULATOR VALVE
WITH STEAM VENT TUBE
This Valve serves as a manual pressure regulator.
By adjusting this Lever you will be able to switch
from PRESSURE to STEAM to CLEAN or from
PRESSURE to STEAM RELEASE to release pressure in
8