User Maintenance Instructions - Russell Hobbs RHNPC401 Owner's Manual

User Maintenance Instructions

6. Wash the Pressure
Regulator under
running water.
7. Check spring-loaded
part before replacing.
8. Align the Pressure Regulator at the CLEAN position,press down
and turn clockwise to secure the Pressure Regulator in place
for storage.
9. When the unit has cooled after cooking, remove food residue
with a paper towel,then wipe with hot,sudsy sponge and
rinse.Dry with a soft cloth or paper towel.Never use harsh
chemical detergents, scouring pads or powders on any of the
parts or components of this Pressure Cooker.
WARNING: DO NOT IMMERSE THE PRESSURE COOKER PAN IN WATER
OR ANY OTHER LIQUID.
NOTE: Do not place the Pressure Cooker Lid, Pressure
Regulator Valve parts, Pressure Level Indicator parts, Lid
Gasket or Pressure Cooker Pan in the dishwasher.
10. The HIGH/LOW Pressure Level Indicator should be cleaned
after each use.Remove the round Pressure Level Indicator
Gasket from the bottom of the lid. With one hand on the
inside of the Lid,press the spring-loaded black cap upwards
into the red Indicator rod while gently rotating the red rod
clockwise until it can be easily removed. You may then
remove the black cap and the spring inside.Clean the area
thoroughly. Reassemble when cleaned.Make sure the
HIGH/LOW Pressure Level Indicator is properly assembled and
the Gasket is securely tucked inside the Lid opening.Press the
Gasket into the Lid opening before using to make sure it is
tight and able to operate properly.
11. Store the Pressure Cooker with the Pressure Cooker Lid off or
upside-down on the Pan.Do not store the Pressure Cooker
with the Pressure Cooker Lid and Lid Gasket closed tightly on
the Pan.
12. For increased safety and best results, the Lid Gasket,Pressure
Level Indicator Gasket and Pressure Lift Pin Gasket should be
replaced every 12 months. For ordering information, call
Consumer Service at 1-800-233-9054.
21
( C o n 't . )